6.5cm Width Brick Wall Mesh(Coil Mesh) fo construction 500G/M2
Galvanized 10-100m length
Brick Wall Mesh for construction for use primarily as an
anti-cracking reinforcement in the construction of brick and block
masonry. Coil mesh is available in a variety of widths to suit most
wall constructions and is supplied coiled for ease of handling.We
could make the width from 6.5cm-20cm. Additional applications
include strengthening cornices, low walls and balconies over door
and window openings.
Specification:
Hole Type: Diamond
Hole Size: 12*25mm
width: 6.5CM,10cm, 15cm, 20cm
Length: 10m-100m
How to Install Brick Wall Mesh?
The coil mesh is laid in strips between brick or block courses
leaving approximately 25mm clearance from the faces of the work.
Where coil mesh joins are required, ensure they overlap by at least
75mm.
The reinforcement is then simply embedded in the mortar for the
next course.
In most instances, application every third course, for the full
length of the wall, will be sufficient.
To reinforce brickwork at an opening, e.g. window or door, mesh
should be installed to overlap part of the opening, and part of the
solid wall.
Thinking of the width of the opening, lay the mesh approximately a
quarter of the way across the opening. The mesh should lie the same
distance again, across the solid wall.
Above windows or doors, install Catnic mesh for 2-3 courses,
starting from the course above the lintel as shown below
Brick Wall Mesh Load in the Container
